I would like some help setting up my antenna.
I had gone out and bought the CM4228HD and I am going to set it up indoors and just temporary set it against a wall until the snow melts, the ground thaws out a bit and it gets a bit more warmer out.
So I got the 4228hd all assembled and I have a short (15 feet) coax (that a Cogeco tech installed) plugged in to it, so if I would like to use the 2 antenna setup (1 pointing north, 1 pointing south-east) and I know I will be risking a 3db loss? with a signal combiner. Do I have to connect the preamp to the 4228hd? or can I run it right to the distro amp and then the signal combiner?
Actually the big question is where do I place the distro amp? After the signal combiner or before?
I made a diagram to show what I am thinking. Hope this helps.
Old Yagi (antenna 2)---------------------\/
4228HD (antenna 1)->Preamp->Coax->Signal Combiner->Distro amp->Tv's?