Post 3 made on Sunday February 13, 2011 at 11:12 |
mostasz Long Time Member |
Joined: Posts: | February 2010 36 |
|
|
I just programmed one of those controllers into our showroom system. Command >N,ON and command >N,OFF does not always work for two nodes, and only for those two. When I send commands to turn on or off to every single node, it works every time. Like that: >N9, 10, 21,22ON and >N9,10,21,22OFF
Just remember about that when you have problems. What's weird that these two are not far away, and have others next to them that work fine with general commands.
|
|
|