On December 29, 2007 at 11:52, brucelee said...
You don't need a macro as long as the Power LED mode in
the RK3 properties is set to Power Status Input, but you
do need to use the screw terminals on the CB4 to connect
to the RK3, the RJ45 connection does not carry the power
status leads (according to the schematic on pg 5 of the
CB4 manual).
Bruce
Bruce, I see that too on the schematic, but on Pg 5 it says that voltage status will be transfered to all touchpanels.
I wonder if that is correct?