On December 29, 2007 at 11:52, brucelee said...
You don't need a macro as long as the Power LED mode in
the RK3 properties is set to Power Status Input, but you
do need to use the screw terminals on the CB4 to connect
to the RK3, the RJ45 connection does not carry the power
status leads (according to the schematic on pg 5 of the
CB4 manual).
Bruce
I know I have a pwr status signal to a screw terminal on the CB-4 block: confirmed by LED on CB4:
only a CAT5 run to TP
are you saying I need to hardwire that line to the TP? I could find a spare in the CAt5 but it seems strange: I can try that next
