I am a custom installer with a client that purchased 4 of these remotes and two have just turned up with no response on the touchscreen buttons. Hard buttons work fine. Is it software or the hardware connection issue? I attempted to clean the contacts as mentioned in PeraV 's thread but the flexible plastic ribbon with the 4 conductors appeared to not have any connector, it looked as though it was attached directly to the capacitive membrane. Any new thoughts? rickak
You have 4 options still: send to fix at philips, put a new touchscreen, use a conductive glue to replace the ribon or finally but not least put in my garbage can.
I purchased a locked up TSU3000 on Ebay recently. I gambled that I could find and repair the problem. If all attempts failed at least I would have extra parts for my functioning unit. After retro upgrading the firmware to clear out the junk from the previous owner I discovered the calibration screen was unresponsive to touch. If you can't get past this screen it is basically a brick. I spent a few hours reading all the stuff from remotecentral users and found this person's video.
This guy hit the nail on the head. I did exactly as described and I now have a fully functioning remote that I only paid 20 bucks for after shipping. Thank You remote central users and thank you Gary Quiring.
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
