Some help please I am after some codes for a Pace satellite box, the guide has no codes listed and I can find no codes online anywhere for pace boxes.

Thanks

Do a search please before asking questions.

A search in this forum of "pace cable" for the last year yielded many hits, including this one:
[Link: remotecentral.com]

Jim

The 9962 doesn't have built-in setup codes for devices not sold in the USA.

Some Pace boxes use setup code 1068. That is not in the 9962, but probably could be loaded via .wav file, either by calling USA customer support for OFA and having them load it over the phone, or by using the JP1 software to convert the posted upgrade for 1068 into a 9962 .wav file.

Have you confirmed that the 9962 can't learn functions from your Pace remote? Other Pace devices (not the ones that respond to setup code 1068) have ordinary IR signals that can be learned by ordinary learning remotes. Even if you want to use a .wav file upgrade, rather than filling the learning memory, it would help to know whether the signals are learnable (whether you need the 1068 upgrade or one for an ordinary IR protocol).

Many Pace Sat devices use the "Sky" standard IR signals rather than any Pace signals. I expect you'd know if your device is one of those, in which case you should be looking for Sky signals rather than Pace signals (also not included in the 9962, but loadable via .wav file). Note that Sky+ signals are a different set from Sky signals (I'm not sure if Pace also makes Sky+ devices) that's yet another setup code loadable via .wav file.

This message was edited by johnsfine on 02/01/05 09:29 ET.

I did search and found that code 1068 does not work!

The remote will learn the codes from my Pace remote, I have to do the same thing with my RCA TV (PAL TV I am based in New Zealand) as none of the codes (of which I have tried many) will work with that.

Annoying thing is my TV has to be turned on by pressing Av and can only be turned off by using the power off button, which means we setting up the macro for home Theatre mode it only works for turning off the TV.

Is there anyway around this with a different code or being using an editor mentioned above to make a wav file.

I am new to all this so if these are dum questions, I have tried to read as much as I can on the site but I am not cleat what I need to do.

Any help very much appreciated.