Post 1 made on Tuesday September 27, 2005 at 20:16 |
jl_folk Lurking Member |
Joined: Posts: | August 2002 5 |
|
|
Is there a way to get into calibration mode on the touch screen without having to run the firmware update ? My remote has been stable for over a year , and I'm not sure I would remember all the tips / tricks / tools I used to get it to this point -- NeoHacker, NeoEdit, etc. I just want to calibrate the touch screen ....
Thx .
|
|
Post 2 made on Wednesday September 28, 2005 at 04:54 |
ac-ste Long Time Member |
Joined: Posts: | November 2002 99 |
|
|
No prblem - press Mode >2 sec. - press Setup - goto page 3/3 - press Calibrate and here we are.
br Steffen
|
|
Post 3 made on Wednesday September 28, 2005 at 14:21 |
tkrug Long Time Member |
Joined: Posts: | July 2002 435 |
|
|
As Steffen said, that will work....but I wouldn't worry about losing your configuration. Assuming you saved your hacked config in neohacker, changing the firmware or anything else isn't going to affect your ncf.
|
-Tim Pronto Neo FAQ: [Link: remotecentral.com] |
|
OP | Post 4 made on Wednesday September 28, 2005 at 16:11 |
jl_folk Lurking Member |
Joined: Posts: | August 2002 5 |
|
|
Thanks all - I knew there had to be a way to do it. However, when I do the calibration I get a message that "calibration failed". Any tips on how to resolve that ?
Regards,
JLF
|
|
OP | Post 5 made on Wednesday September 28, 2005 at 16:19 |
jl_folk Lurking Member |
Joined: Posts: | August 2002 5 |
|
|
Update - I searched the forums and found a solution to the "calibration failed " message, but it didn't seem to address the root issue of the screen being out of calibration.
If I touch the calibration target on the upper left of the screen about 0.25" to the left of the actual target, I can get the unit to say "calibration succeeded". However when I go into "use" mode the screen is still slightly out of calibration.
Any other tips would be appreciated .
Regards,
JLF
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.