I'm in the process of formulating a spreadsheet that would allow anyone with a Pronto to generate a Xantech codeset using MakeHex and the file NEC.irp.

I've identified the patterns that the Xantech remote sends based on the button numbers on an RC68+. However, I'm missing 2 values that are not specified by buttons on the Xantech remote. I won't go into lengthy details here as I plan to cover the explanation in a public document I'll publish to this site. I also don't have an RC68+ and don't necessarily want to spend the $$$ to get hold of one. However, if someone out there will learn ONLY 2 codes for me, I can verify my assumptions and complete the data set.

Here's what I need. Someone with a Pronto, please select the codesets below and learn the IR signal for the Xantech RC68+ Button labelled '00' and post either the 900A or 0000 Pronto Hex Format results.

Codeset 0x02 (Top/Left Dial set to 0, Bottom/Right Dial set to 2)
Codeset 0x04 (Top/Left Dial set to 0, Bottom/Right Dial set to 4)

If you can please post these codes, I can get the data compiled and then publish the results. If you don't want to post, please email me with results @ email addy on my profile.

Thanks in advance,
Lyndel McGee

This won't work?
[Link: remotecentral.com]

Lyndel, E-mail me if estech's link does not help you. I will forward you the xantech ir codes in a pronto file format. Let me know what pronto (1000/2000 or 3000/3500 or 7000/7500) you are using.

Aaron

Unfortunately, that won't work. I've been through all the xantech files on this site for the Pronto and NG remotes and the patterns I need are not there.

Thanks for the heads up though.

I have a remote back at the shop, I am on vacation this week. If you have not got your hands on the codes I will learn them for you. I'll check back here now and again, or you can e-mail (profile)as the week come to an end.

Anybody here work or live around the outer banks NC??

Thanks to JCL, the answer I needed is here....


[Link: remotecentral.com]

Do you have the spreadsheet you mentioned in this thread.

I need the codes from the RC68+ for the C8 Code Group. Specifically for the Gatekeep-IR.

Any help would be much appreicated.