|Post 1 made on Sunday January 5, 2020 at 22:32|
I have the CCP from my dealer version 3.9 1127.1. I made some changes to my system but I cannot get my remote to learn the code for the on or off function of the 2 button remote that comes with the 1850G. Any help would be greatly appreciated. I am not sure what I am doing wrong. I can get the CCP software into the learn ir mode but it will not learn. I have held the remote close and far, front and back (not sure where the input for learning is on the MX 780. I am using IR only no RF Mod. Is there way to try to go head to head to the remote only to try to get it to lean the IR codes?
Thank you for your help.
|Post 2 made on Monday January 6, 2020 at 08:21|
the end you point at the device you want to control, is also the end of the remote that learns codes from other devices. Usually if you hold the remotes end to end about an inch away, that will work.
I'm not familiar with that monster hdp, but from what I looked up, the original remote is RF, which means you won't be able to teach those codes to the mx780 remote. As far as I can tell, there isn't even an IR remote option for that unit, so I think you are stuck.
|OP | Post 3 made on Monday January 6, 2020 at 23:09 |
Thank you for the reply. I will just deal with it.
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.