Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Sunday January 5, 2020 at 22:32
mwasmuth
Lurking Member
Joined:
Posts:
November 2012
4
I have the CCP from my dealer version 3.9 1127.1. I made some changes to my system but I cannot get my remote to learn the code for the on or off function of the 2 button remote that comes with the 1850G. Any help would be greatly appreciated. I am not sure what I am doing wrong. I can get the CCP software into the learn ir mode but it will not learn. I have held the remote close and far, front and back (not sure where the input for learning is on the MX 780. I am using IR only no RF Mod. Is there way to try to go head to head to the remote only to try to get it to lean the IR codes?

Thank you for your help.
Mark


Hosting Services by ipHouse