On February 27, 2007 at 12:20, tweeterguy said...
It's likely they are on the same channel as you or you
are on channel zero on your base (mistakes happen right)?
No I am not on Channel 0 I am on Channel 4. Mistakes do happen but I am doing IR Routing and know that I am not on RF ID 0.
One thing to note (as an example), if your remote programming
is on RF channel "C" and the mrf is on channel "C" then
the base AND rfx will flash with commands executing.
If on the other hand your programming is on "zero" and
the mrf is on "C" then ONLY the rfx will flash, not the
base when executing commands. This holds true for all
channels including zero in programming.
0 is a sniffer channel. You can not do any IR routing on Channel 0 and it will accept all codes sent by any RF ID Number.