Post 16 made on Saturday March 6, 2010 at 18:19 |
Glackowitz RC Moderator |
Joined: Posts: | May 2002 3,793 |
|
|
Has anyone got a working 8870 setup with 2way??
The system I installed works for setting the mode...Heat, Cool, Auto, Off, but temp feedback, Setpoints, dont work. If I press the setpoint buttons up or down I get no fb on the 8811, I set it up as a 1way with the 232 strings and can get the setpoints working fine, but now have no fb.
The denon receiver, weather fb works fine,
I have changed Ports and then redid the commands, changed addresses, changed baud stil nothing for FB
Any ideas??
Cables have tested fine, as the 1 way 232 was sending fine(as well as I have metered them)
Thanks
|
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|