On January 25, 2010 at 16:04, Spaceman said...
I have tested v1.39 now. Denon receiver volume works great.
Button response is much better now, but after several button presses the module is locked, or at least apears to be locked.
Going to the homepage and then back to the module it works again.
Also Audio+/- and Subtitlr+/- does not work on DVD2500(blueray).
The codes that work on this player is:
Audio + 02 49 2B 2B 00 00 00 03 41 32
Audio - 02 49 2D 2B 00 00 00 03 41 34
Subtitle + 02 4A 2B 31 00 00 00 03 41 39
Subtille - 02 4A 2D 31 00 00 00 03 41 42
Thanks for the good work!
Regards
Jesper
I already use that:
BD Audio+ \x49\x2b\x2b\x00\x00\x00
BD Audio- \x49\x2d\x2b\x00\x00\x00
BD Sub+ \x4A\x2b\x31\x00\x00\x00
BD Sub- \x4A\x2d\x31\x00\x00\x00
I'll make a debug version for it this weekend. I need to push 1.40 back anyway, still no BD player to test with, let alone a IP BD player. Might be a uppercase/lowercase hex problem. However I see that I've used lower and higher for DVD aswell and those work. I'll send you a version with only uppercase (\x2b->\x2B).
As for the module stopping, set the general delay from 20 to 200 and check again. It might be because of timing issues or a broken command on bluray, as I don't own one I can't test it. As you can see in the youtube movie from the startpost it runs great on a DVD3910.
Last edited by sWORDs on January 25, 2010 18:17.
