It had been suggested to me to try this code: 0000 006D 0000 0032 0083 0042 0010 0010 0010 0031 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0031 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0031 0010 0010 0010 0010 0010 0031 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0031 0010 0010 0010 0031 0010 0031 0010 0031 0010 0031 0010 0031 0010 0010 0010 0031 0010 0010 0010 0010 0010 0031 0010 0031 0010 0031 0010 0031 0010 0031 0010 0AED, NEOHacker converts it to: 0 f 6c 4 61 82 10 31 42 83 3f 5f bc 2e 10 0 0 0 0 0 10 0 0 0 0 10 0 1 0 0 1 11 11 1 1 10 11 11 7c 3, which is similar, but not the same as: 0 f 6c 4 64 7c 10 30 40 80 3f 5f bc 2e 10 0 0 0 0 0 10 0 0 0 0 10 0 0 0 0 1 10 0 0 1 10 0 10 7c 3, which was what I tried earlier.
I'm not sure if I'm using NEOhacker correctly, because before moving the new code into the .ncf with NEOhacker, the command would cause my indicater light on my Xantech repeater to flicker, after I loaded the new code into NEOhacker and saving it, and loading it innto the remote with Freedomedit, the Xantech indicator light just lights up - no flicker.