Post 1 made on Monday December 18, 2006 at 12:49 |
zelmo Long Time Member |
Joined: Posts: | October 2006 21 |
|
|
Greetings:
My month-old 9600 has developed a behaviour quirk: If I've been using it continuously for a few minutes (debugging screens, macros, etc) and then stop, the LCD backlight goes off after the period of time that I've set in the Setup page. So far, so good.
But, when I pick it up (tilt switch) or push a button, sometimes it takes a couple of seconds for the back light to come back on, and when it does, it comes on at a very dim setting for about a second, then it behaves normally.
It didn't do this when it was new. The battery is fully charged, and I haven't changed anything lately, except that I did install the latest firmware last week, as suggested by a previous post on this forum.
Has anyone else seen this, and if so, is there a solution? It isn't a serious problem, but I don't think this is supposed to happen.
BTW, my configuration isn't extensive, so I doubt that it's a low memory situation.
Thanks,
-doug-
|
|
|