Post 2 made on Saturday June 2, 2007 at 09:59 |
1ziggi1 Long Time Member |
Joined: Posts: | September 2006 410 |
|
|
You could try to reset the remote by holding down the main button until the setup screen comes up and then restore to factory defaults. Just make sure that you have a backup of your work as this will reset to factory defaults and then you must re-upload your file to the remote. Also there is a reset button in the battery compartment which will not require you to re-upload your file to the remote. Also check your IR/RF settings in the editor program.
|
|
|