Post 1 made on Monday September 26, 2005 at 13:33 |
Hi all i installed the new firmware Version 3.8.11 - since then all my macros with built in delays do not work anymore. All delays are set to 0.15 sec., the IR-Code duration is always set tho default. I use these macros to select TV-Stations > than 9 e.g 10, 11,...
I played around with several delay- and duration-time settings, but with no success.
Fortunately i was able to restore firmware 3.7.7 - now it works again.
Any idea or solution?
Regards Daniel
This message was edited by dabu on 09/26/05 14:00 ET.
|
|
|