On March 17, 2007 at 11:50, inajeep said...
I spoke too soon part two. A day after the replacement
a small crack appeared at the edge, a 2nd day later another
crack on the bottom right and the third day later a long
crack all the way through. I"m sure I put the unit back
together properly. I can't understand what would cause
stress cracks in that manner. If I over tightened the
torx screws maybe but I just snugged them up. What ever
the reason I am left with the decision to try again or
just get a different remote.
Man you have search and read before do-it-yourself. The replacment glass is a little bigger them the OEM one. So you need to work with a dreamel on the plastic frame to make room for it. For shure you did not noticed that when you closed your control the frame was too far from the glass and then you tightened the screws puting a lot of pressure on the glasstop edges. You have to work with a dreamel and cut the tabs in the ineer part of the plastic frame.
Last edited by ossocao
on April 19, 2007 11:40.
