Post 104 made on Tuesday August 30, 2005 at 11:23 |
corwyn Lurking Member |
Joined: Posts: | August 2005 8 |
|
|
My TSU3000 pooped out on me a couple of days ago, and after recharging the battery pack (brand new) completely, doing a button reset, and doing a battery-pull reset...but none of them seemed to work. Yesterday, it randomly started working again, but only for a few minutes.
It seems like the touchscreen is registering my touches about 2 inches to the left. e.g.-if I press on the far left side of the screen, soft buttons towards the right side of the screen (like the device navigation right arrow at the top) activate.
How can I see about sending my Pronto in to get checked out, too? Not sure what firmware I have, and I can't access the information screen since the appropriate soft key is on the left side of the page :-(
Edit: It's 3.1.15. I just upgraded to 3.6.7, and now I'm getting the "calibration failed" message when I tap the top right corner during calibration.
This message was edited by corwyn on 08/30/05 16:20 ET.
|
|
-Corwyn |
|