Simple, run Cat5 to the box ensuring that all low voltage wiring stays .25 inch away from the high voltage as per spec in side the box. Grab a Xantech emitter, cut off the jack leaving a few inches for splicing latter and break off the plastic shell. Remove the graphic Eye faceplate, hot glue the emitter next to the receiving eye. Crimp the emitter’s pigtail {observing the polarity} on to a couple of the cat5 wires using phone wire crimps. Connect the jack end of the emitter wire to the corresponding cat5 wires on the other end and further, to your connecting block; carefully install the graphic eye into the wall box.

Other wise get your self an Ir Blaster.


Enjoy