On July 22, 2007 at 14:43, ckleiman said...
This solution also worked on the same new model. You only
need to send the RS232 enable command once.
vwpower44's response, quoted above, seems to say you can't send it twice or it will undo what was done. Okay, you say it only needs to be sent once. What if, by mistake, you send it again? And do you understand what he means?
I suggest
putting some delay before sending the POWR 1 command.
In Vity software this was simple to do. Unfortunately,
am not familiar with RTI.
What is Vity software? What particular Vity product are you using (in case they have more than one product) ?
