On 10/19/04 15:40 ET, IanG said...
Don
I've downloaded ver 2.2.577 and loaded it onto
my Axim x30. Unfortunately I'm having problems
with a macro I have recorded in native mode.
While it executes correctly (I still need to fine
tune the timing) it starts looping continuously.
I have checked the pdf file and the site here
but I can't find any references to this sort of
problem. I assume I am seeing an odd symptom
of not having done something correctly - any suggestions?
Hmm. I'm afraid my only suggestion is to run around the room in a tight circular pattern screaming out warnings of the end-times, but that doesn't seem very useful in solving your problem. ;)
Can you send the RCDEV file to the TRBeta team at trbeta_at_griffintechnology_dotcom? I think it might help if we analyze it and see if there is an abnormality in the file.
--Don
