The following page was printed from RemoteCentral.com:
Post 2 made on Sunday October 28, 2001 at 15:02 |
Matt Cosman Founding Member |
Joined: Posts: | August 2001 12 |
|
|
couple of possibilities. Have you told the T2 that it is supposed to send RF commands instead of IR? I so then which RF address did you send it to. There is a rotary switch on the back of the IRF-6 which should be at 0 as a default. Then in the programming under edit remote properties there is an option to make all commands RF and then you can specify which address. Hope this helps.
|
|
|
|