Post 1 made on Tuesday October 23, 2001 at 21:44 |
christopher H. Founding Member |
Joined: Posts: | October 2001 5 |
|
|
I am having problems with my IRF-6 unit when I plug in the unit the light flashes twice it supposed to be ok but it doesnt respond to my commands
This message was edited by christopher H. on 10/24/01 03:27.30.
|
|
Post 2 made on Sunday October 28, 2001 at 15:02 |
Matt Cosman Founding Member |
Joined: Posts: | August 2001 12 |
|
|
couple of possibilities. Have you told the T2 that it is supposed to send RF commands instead of IR? I so then which RF address did you send it to. There is a rotary switch on the back of the IRF-6 which should be at 0 as a default. Then in the programming under edit remote properties there is an option to make all commands RF and then you can specify which address. Hope this helps.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.