I believe the following procedure still works with the newer Mits as it did the older ones. This will convert your Mits remote into a discrete mode that should give you the input switches you're looking for:
Set the Slide Switch at the top of the Mitsubishi Remote to TV.
Press and hold the POWER button, and while holding the power button enter 090.
Now the remote functions like this:
Power = Power On Only
Stop = Power Off Only
Pause = AV Reset
Pressing DEVICE followed by:
PIP = DTV (HD Input)
1 = Input 1
2 = Input 2
3 = Input 3
4 = Input 4
5 = DVD / Component 1
6 = Component 2
SQV = Input STB, Input 5 or DVI (depending on model)
QV = Input VGA
PIP CH Up = Antenna A
PIP CH Down = Antenna B
SQV = Front SVideo
QV = VGA
PIP/POP = OTA HD Antenna (Built-In HD Tuner)
Learn the desired commands to your MX-500.
When done, press and hold POWER button and enter code 000 (935 with NetCommand models) on your Mits remote to return to its normal functioning mode.
For older model Mits, use the "Input" key instead of "Device".Mike
www.surfremotecontrol.comThis message was edited by MikeSRC on 03/20/04 18:44.