On May 9, 2006 at 17:39, rosariorose9 said...
hiker,
Thanks very much for the link - that didn't turn
up in my forum search. I'll give it a try tonight.
By the way, the unit is not set to '0' - it's
set to 3 (so we know that at least that's not
the problem).
rosariorose9
Set it back to 0 and check your placement for interference. If the codes work some of the time, this is most likely your problem. If there is interference the STATUS light will blink. Every time this light blinks it would translate to a missed command sent by the remote.
