Post 1 made on Sunday August 1, 1999 at 17:13 |
Chris K Historic Forum Post |
|
|
I've just started recently with X10 and have made an annoying discovery. The RF Appliance/Receiver modules only receive (and redistribute via X10) RF from one house code.
Luckily, I started out buying two starter kits (Firecracker, then IBM HD), so I have two RF/Appliance modules, and have set them for different housecodes.
I've recently purchased some more light modules and 4 Hawkeyes to get more out of it. With the Hawkeyes taking up 2 units each, I may start running low on unit codes in the future.
Anyway... the question is. Is there an RF receiver that receives all 16 housecodes, so I can logically group these items and not run tight on unit codes?
Also, I've noticed that the 2WayAppliance/Xcvr unit included with the Firecracker deal only responds to it's house/unit code if sent by RF/Firecracker, not if sent by the CM11. (It's not an X10 signal issue. A lamp module in the same plug will respond to X10 commands).
--Chris
|
|
|