On August 8, 2019 at 22:15, tweeterguy said...
Incorrect.
You seem to be operating on theory rather than practical experience.
Wire it exactly as I have said, twice now.
Connections:
Z2IO Relay is bound to FP control relay.
Z2IO contact is bound to generic contact driver.
Programming for contact:
When contact opens, select FP
When contact closes, select FP
The toggling of the mechanical switch will toggle the state of the FP.
Programming for KP:
When button is pressed, set FP timer to off mins
When button is triple tapped, set FP timer to 30m
(led tracking programming omitted on purpose to not cloud the discussion)
If FP is turned on elsewhere than the mechanical switch, ie my KP programmed to start FP timer to 30m, toggling the mechanical switch (no matter if it is up or down) will cause the FP to go out.
I stand by my post. Reread what you wrote and my response and tell me where the error is in my response.
Last edited by crosen on August 9, 2019 05:43.
