On October 27, 2017 at 11:11, ericspencer said...
Those micro switches are both NC and NO, that is what the unused tab is on the switch. Figure out which one the open tab is ie NC or NO and figure out a way to make that be your trigger.
That was the first thing I tried.
Somehow, and I still don't know why, it didn't work.
While using common (middle) tab and unused one, the board would go trouble.
Going inline with the signal would do the same. That one I expected actually.
Since then, I was able to figure out the board's model and found that there are dedicated contact points for what I'm trying to do, so I'll be pursuing that avenue.
Thanks for suggestion.