Post 1 made on Sunday April 5, 2015 at 11:05 |
lovemshaved Long Time Member |
Joined: Posts: | November 2011 10 |
|
|
I have a mx6000 remote with the cpp software and I am a L1 lutron ra2 installer, but I'm having a heck of a time trying to get my mx6000 to control my ra2 system, I have essentials 8.2 running a full lutron system. To figure things out I was only trying to control my office light where I do the programming, I have the mx6000 connected to the wifi through the ccp program no problems but when I try to connect to the two-way module programmed into my mx6000 it tells me either it cannot connect to the network (when the remote is not plugged into the laptop) or when it is plugged into the laptop it connects but then says it is switching back to 1-way because all of the 2-way modules are being used by other devices,
any help anyone? i've gone through this many times and always the same outcome, what am I missing or doing wrong?
thanks in advance
|
|
|