On November 16, 2013 at 11:42, bizwiz41 said...
How do you have these devices connected? I assume you are using HMDI connections through the AVR.
So, is the "channel" that first comes on a "stereo" channel? The Pioneer should "remember" what the last "non-dolby" setting was, until it detects a Dolby signal.
I have each device connected into the Pioneer via HDMI cables & then (1) HDMI cable out of the Pioneer into my display. And no, the 1st channel that comes up when it's first turned on is not a "stereo" channel, it's a DD 5.1 channel. Like I said, when it comes on initially, regardless of what channel the SAT was on when it was turned off, it will display "Stereo." Then I just change the channel up & then back down to show the true audio decoding, which would be Dolby Digital. It's an obvious glitch; I just need some advice on how to program the Harmony to correct it.
Ken