Post 1 made on Friday April 19, 2013 at 18:05 |
KeepAGun Long Time Member |
Joined: Posts: | January 2013 53 |
|
|
Hello,
MX-3000 Standalone Editor 418MHz Lamp Dimmer MRFA-3LD-URC
RF Setup: Signal: RF Receiver: Dummy Called Light
Programming Remote: IR Data from LIGHT Brand: UNIVERSAL REMOTE CONTROL* Unique 4 Digit Lighting Address Entered and saved to buttons for Lighting Device Copied "ON" command to a Hard Button
Programming Dimmer: Press and hold big button until leds steps up to top, light only on top led, then leds cycle down, start at top again and cycle down continuously. Continue to hold big button on dimmer while this is going on then press MX-3000 "ON" button I copied to hard button.... nothing happens.
No matter what I have tried, the switch will not respond at all the the MX-3000. Any ideas? Could it be I have a bad dimmer switch? Switch works manually just fine.
Thank you for any help on this matter.
|
|
|