Post 1 made on Friday April 19, 2013 at 18:05 |
KeepAGun Long Time Member |
Joined: Posts: | January 2013 53 |
|
|
Hello,
MX-3000 Standalone Editor 418MHz Lamp Dimmer MRFA-3LD-URC
RF Setup: Signal: RF Receiver: Dummy Called Light
Programming Remote: IR Data from LIGHT Brand: UNIVERSAL REMOTE CONTROL* Unique 4 Digit Lighting Address Entered and saved to buttons for Lighting Device Copied "ON" command to a Hard Button
Programming Dimmer: Press and hold big button until leds steps up to top, light only on top led, then leds cycle down, start at top again and cycle down continuously. Continue to hold big button on dimmer while this is going on then press MX-3000 "ON" button I copied to hard button.... nothing happens.
No matter what I have tried, the switch will not respond at all the the MX-3000. Any ideas? Could it be I have a bad dimmer switch? Switch works manually just fine.
Thank you for any help on this matter.
|
|
Post 2 made on Friday April 19, 2013 at 19:53 |
Lowhz Senior Member |
Joined: Posts: | April 2012 1,168 |
|
|
You need to teach the lighting commands in via IR from another URC remote that will use the generated codes in the CCP editor.
You have addresses 0001-0020 available to you.
|
|
Post 3 made on Friday April 19, 2013 at 21:23 |
MattBrotzge Long Time Member |
Joined: Posts: | June 2007 426 |
|
|
I also have an mx850 file with those lighting code sets that tech support gave me if you want to import the commands or copy and paste the hex commands.
|
Matt Brotzge |
|
Post 4 made on Friday April 19, 2013 at 21:27 |
MattBrotzge Long Time Member |
Joined: Posts: | June 2007 426 |
|
|
Oops I forgot you can also download that file on the dealer website; urccontrolroom.com. It's located under in technical resources section under templates and files.
|
Matt Brotzge |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.