I was looking to try to get some commands tested for the DBP-2012UDCI, really just looking for "power on" "play" an "stop". But if i had one or two I believe I could figure out a few more.

This is for an elan system i believe I have the right settings for the serial
Baud Rate 9600
Flow Control none
Parity Even
Data Bits 8
Stop Bits 1
As for the command I have a place for ASCII that will fill out the hex when I type it in.
the terminator can be "None" "Carriage Return" "Linefeed" or "Carriage Return + Linefeed"
Any help would be very much appreciated.
Thank you in advance.