Post 16 made on Monday June 18, 2012 at 08:38 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
just a tip:
when using an RF base station, it is a good idea to add all the devices to the configuration and alias each command that you need to use in your macros. then use punch through to assign all the hard buttons. this way you can assign an ir port for that device and the rf routing will always be correct even if you need to add commands from multiple devices to the same macro.
when you drag ir commands into macros using the database, they will only route to the port assigned for that page, so if you have two devices that share the same codeset, they will be responding to the same commands.
even if you are not using an rf basestation, this method will make it easier to change out devices in the future.
|
|
|
|