This is going to be a troubleshooting nightmare. I used win7 to load the blank template to the 880 and it worked. When I load my configuration, it fails. But when I load my configuration using the same ccp software version under winxp on my vim, it loads fine to the 880 ...

How do you explain that? The only method i can think of here is complete trial and error. Remove all devices and load them one at a time back into ccp and download to the remote. Can't imagine the pain and time this will take, my setup is pretty complex, two outputs/projector and TV and five devices plus the msc400 triggers, favs, macros, jumps, hiddens, etc...

Config works on same software release under XP, but not Win7... How is that not a software problem?

Anyone recommend a method to troubleshoot besides above?