| Post 2 made on Monday January 2, 2012 at 20:04 |
ctuinstra Long Time Member |
Joined:
Posts: | November 2007
19 |
|
|
I finally figured it out. I got stuck on the names of the IR Data when actually the entire page of commands that I copied from another section (device) did not work. All I needed to do was to set the output of the new device to go to the MSC400. It just wasn't communicating with the MSC400 at all.
I spent hours earlier today and was about to give up when I posted this.
| |
|
|
