Post 1 made on Monday January 2, 2012 at 19:29 |
ctuinstra Long Time Member |
Joined: Posts: | November 2007 19 |
|
|
I have a bunch of commands already setup and working from years ago, so the backbone of the systems works. I'm trying to add a couple more and can't get them to work. First I have the new RS232 commands programmed in the MSC400 and doing a test of them works fine. Now when I use the Universal Browser in the MX3000 programming software (CCS) and drag and drop them into the IR commands for the button, they are labeled "Room Light_UB" whereas my older working commands are labeled "Room Light.ccf". I cannot for the life of me figure out what I am doing different or wrong.
Thanks for any help!
|
|
OP | Post 2 made on Monday January 2, 2012 at 20:04 |
ctuinstra Long Time Member |
Joined: Posts: | November 2007 19 |
|
|
I finally figured it out. I got stuck on the names of the IR Data when actually the entire page of commands that I copied from another section (device) did not work. All I needed to do was to set the output of the new device to go to the MSC400. It just wasn't communicating with the MSC400 at all.
I spent hours earlier today and was about to give up when I posted this.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.