We are slowing learning SB using our demo Prodigy gear. I have setup a PMC3, idocv, and PLX3 using system builder and cannot figure out why I only get a Crestron swirl logo on the remote. I have built and rebuilt with the same outcome. I am very new to the programming, so I am sure I have screwed something up, however, we also have the PTL keypad and in a separate SB file we were successful at getting it up and running using the same processor.

I am beginning to wonder if the remote is bad. At the Finish page, all devices and interfaces have green checkmarks and I received no errors. Network ID's are all found and hardware all verified.
Are there any "snags" on the PLX3 in SB that I have hit and just can't see? It seems like I would at least get a home page on there or something.
Sorry for such a vague issue, but Im not sure how to break it down any more than this. TIA.

Also - Composer yielded the same results...