Post 1 made on Tuesday June 22, 2010 at 12:11 |
rudy111 Long Time Member |
Joined: Posts: | January 2010 22 |
|
|
Hello guys;
Suddenly my 9400 reported "Command failure' (no further explanation). I found out that the commands from the 9400 didn't reach the RFC 9400 extender. There was no reason for it: no network/configuration/PEP-changes, only minor adjustments in some images. Also the Extender Discovery Tool in PEP didn't find the extender altough the extender was fully functioning. Solution: turn exender off and on, replace the axtender-firmware and the Pront- connection is established again! However, the Extender Discovery Tool still cannot find the extender...
What can I do to avoid this problem in the future?
Thanks, greetings, Rudy
|
|
|