| Post 1 made on Monday December 7, 2009 at 06:23 |
mob Lurking Member |
Joined:
Posts: | December 2009
1 |
|
|
I have recently had an LCD display fire installed which is hardwired to a spur taken from a power point. This socket is now becoming 'deaf' to X10 signals. It will switch 'off' but not 'on'. When the spur is switched off, the socket works normally. Obviously a noise problem from the fire but how do I correct this when it has no socket? Incidentally, I am in the UK which may make a difference to replies.
|
|
| Post 2 made on Thursday December 10, 2009 at 00:49 |
Daniel Tonks Wrangler of Remotes |
Joined:
Posts: | October 1998
28,785 |
|
|
They do have in-line or circuit filters you could try.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
