| Post 1 made on Thursday June 21, 2001 at 22:46 |
Chris Shatara Historic Forum Post |
|
|
I'm having a "problem" with unexplained delays in a
sequence at a point when I am turning on or off a
non Sony Receiver.
I've changed the settings for the system control
buttons and all the device buttons to the standard
default delay of approximately 170ms but still no
help.
Any ideas?
|
|
| OP | Post 2 made on Friday June 22, 2001 at 03:57 |
Daniel Tonks Historic Forum Post |
|
|
Is it always the same point? Are you using learned or preprogrammed codes?
|
|
| OP | Post 3 made on Friday June 22, 2001 at 10:47 |
Chris Shatara Historic Forum Post |
|
|
Always at the same point.
I'm using a mix of learned and preprogramed codes.
Mostl preporgramed.
|
|
| OP | Post 4 made on Friday June 22, 2001 at 10:53 |
Chris Shatara Historic Forum Post |
|
|
The delay occurs ALWAYS after a command has been issued
to my Amplifier...an Onkyo 575. The command is issued,
acted up by the equipment (the receiver here) and then
the remote delays for one - two seconds before continuing with the sequence.
Doesn't matter where in the sequence I put the AMP.
AMP code is set to 085.
|
|
| OP | Post 5 made on Friday June 22, 2001 at 15:51 |
Daniel Tonks Historic Forum Post |
|
|
OK, how about the specfic command we're dealing with -- did you learn it. The AV2100 has a huge memory buffer that could hold 2 seconds of gargabe before or after a code... try re-learning if that's what you did. Otherwise, let me know.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
