| Post 1 made on Thursday July 11, 2002 at 09:56 |
Berndt Schopper Lurking Member |
|
|
My beamer needs a two second pushed power off command and I would like to programm a system button for shutting down the whole "theatre". The system delay macro executing time function only works with component buttons, would be ok either, but nevertheless it sends the command only for (half?) a second, regardless what I adjust. Am I doing something
wrong, is it really possible to programm a 2 second lasting sending command?
Any ideas?
|
|
| Post 2 made on Friday July 12, 2002 at 23:56 |
Daniel Tonks Wrangler of Remotes |
Joined:
Posts: | October 1998
28,766 |
|
|
No, it's not possible to automate something like that in a macro. 2 seconds is too long to teach (the remote would finish learning before then), you can't set hold times, and the minimum delay between steps is too long to use multiple short codes.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
