| Post 1 made on Monday January 10, 2005 at 07:21 |
RideBo Lurking Member |
Joined:
Posts: | January 2005
2 |
|
|
Hi, I'm using the Sony AV2000T to control my H/K AVR 25II. It all works very well exept for the point that when I select the AMP on the Rm the amp turn on or off. When I selected another component I have to use the on/off button on the remote.
I want to change the Amp selector so it does NOT turn on/off but just selects, like the rest. I do have a manuel but cann't figure this one out. Help!!!!!!!!!!!
|
|
| Post 2 made on Monday January 10, 2005 at 09:16 |
Ron Aronson Super Member |
Joined:
Posts: | June 2002
3,967 |
|
|
The only thing I can think of is that the power command has been learned on the amp select key.
To delete the command, see page 25 of the manual: To clear the learned function of the component select button.
Press and hold Commander off, then press Vol + and Program +, and release.
Press and hold Reset, then press the component select key.
|
|
| OP | Post 3 made on Monday January 10, 2005 at 10:19 |
RideBo Lurking Member |
Joined:
Posts: | January 2005
2 |
|
|
Ron thanks, that trick was not in my manual, it was another combination and it did not work.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
