| Post 1 made on Sunday October 26, 2003 at 16:23 |
gtgold Lurking Member |
Joined:
Posts: | October 2003
3 |
|
|
I have successfully programed all of my other components (mostly using the learn function)but cannot get my receiver to respond to my Sony AV3000. I have tried the codes supplied with the AV3000 unit and even tried to "learn" the remote. The remote seemed to learn (i.e. one beep) but still did not control the receiver functions. Any suggestions would be appreciated.
|
|
| Post 2 made on Sunday October 26, 2003 at 17:58 |
edmund Elite Member |
Joined:
Posts: | April 2002
13,822 |
|
|
Your receiver's oem remote is both a Two-way and RF remote. Can you even see a IR sensor on the front of your receiver? On some RF controlled receivers, disconnecting the RF antenna, enables the front IR sensor.
|
|
| OP | Post 3 made on Sunday October 26, 2003 at 20:15 |
gtgold Lurking Member |
Joined:
Posts: | October 2003
3 |
|
|
Thanks. I looked into it further and you got me on the right track. Unfortunately, I think I'm going to have to get a IR receiver. The unit only sends back an IR signal to the remote, it receives an RF signal.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
