 |
 |
|
|
Sony Remote Controls Forum - View Post
|
|
 |
|
|
|
 |
|
The following page was printed from RemoteCentral.com:
|
RM-VL900 and Kenwood VR-309 receiver
| |
|
| Topic: | RM-VL900 and Kenwood VR-309 receiver This thread has 4 replies. Displaying all posts. |
|
| Post 1 made on Saturday July 19, 2003 at 11:54 |
Hello,
I've setup the RM-VL900 to control all my components. However, it is lacking some controls for my receiver (Kenwood VR-309). I cannot switch between various video input sources (using the Video 1, Video 2, and Aux keys on the remote). The audio source keys work great. I tried to learn the video switch button from the original remote - but the RM-VL900 will not learn any commands from this remote (BTW, it learned commands from my other remotes just fine). Anyone have any ideas about how to solve my problem?
|
|
| Post 2 made on Friday October 17, 2003 at 00:32 |
richard sheridan Lurking Member |
Joined:
Posts: | September 2003
1 |
|
|
I contacted Sony about this problem and they were of little help. They said "We suggest that you please try using the learning feature and learn the non-preset functions. Please refer the page number 15 of the Instruction manual for further information on using the "learn" feature." Great help they were. I started to play with it and found that you can use the learn feature but you have to press the Kenwood Video button multiple times for each video selection on the Sony remote. Try this:
*On the Sony, press and hold S for 3 seconds, press AMP, press 1 (Video 1)
On the Kenwood, press and hold Video till the Sony light goes out
*On the Sony, press and hold S for 3 seconds, press AMP, press 2 (Video 2)
On the Kenwood, press the Video twice and hold on the second press till the Sony light goes out.
*On the Sony, press and hold S for 3 seconds, press AMP, press 3 (Aux)
On the Kenwood, press the Video 3 times and hold on the third press till the Sony light goes out.
It worked for me. Good luck.
|
|
| Post 3 made on Friday October 17, 2003 at 13:10 |
BobG Long Time Member |
Joined:
Posts: | November 2002
11 |
|
|
Can I set the VL900 to send different signals to switch my components on and off rather than the on/off toggle signal? If so how?
|
|
| Post 4 made on Friday October 17, 2003 at 13:11 |
BobG Long Time Member |
Joined:
Posts: | November 2002
11 |
|
|
Oops, sorry. That should have been a new post
|
|
| Post 5 made on Friday October 17, 2003 at 14:00 |
Ron Aronson Super Member |
Joined:
Posts: | June 2002
3,967 |
|
|
See your new thread for reply
|
|
 |
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|
|
