| Post 1 made on Sunday July 7, 2002 at 13:07 |
Just picked up a VL1000. I have a pioneer VSX-D557 receiver and on its remote, there are separate buttons for center, surround, sub. When pressing these buttons, the remote sends a quick pulse to the receiver - which I can tell by the quick flash of light on the remote.
Unfortunately, this pulse is much too short for the VL1000 to learn. Is there ANY thing I can do? I would assume this would be a problem with ANY learning remote.
Thanks for any help.
|
|
| OP | Post 2 made on Sunday July 7, 2002 at 23:32 |
Never mind. I discovered that pressing the center or sub or surround button causes the level +/- buttons to change their function. The level +/- buttons can be programmed without a problem. I'm good to go.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
