| Post 1 made on Saturday March 17, 2001 at 00:13 |
george Historic Forum Post |
|
|
I seem to be having a few problems with my rmav 2100. Codes supplied by sony for jvc rx 9000vbk receiver gives no response. I learned all functions from one remote to the other except my jvc receiver remote has a seperate power and standby button. The standby shuts the receiver down and the sony commander will not learn this command. I can power up my receiver but can't shut it down. I'm not able to use macro's to full extent and the only way to power up receiver is to hold down the power button on sony commander(which was learned)for about 3/4 of a second. I should mention JVC remote sends out IR/RF signal. Any and all suggestions would be greatly appreciated.
|
|
| OP | Post 2 made on Friday April 20, 2001 at 18:44 |
Hi,
I don't know if it's relevant, but see my message titled: VL900 and JVC VBK9000.
Ed
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
