Post 1 made on Wednesday December 10, 2014 at 22:50 |
teek5449 Lurking Member |
Joined: Posts: | December 2014 1 |
|
|
I have recently purchased a Sanyo DP58D33 TV and I have been struggling with finding the discrete codes for the specific inputs (if any). I have an OneForAll URC-6131 that I program using Remote Master and the IR.exe program. I have run through a couple NEC1 protocols but after a a few hundred I am at a loss.
Any help with the correct protocol, device number, and any discrete codes that are known would be fantastic. Unfortunately after a few hours of searching there does not appear to be any current information that applies to Sanyo TVs in the last few years that reference discrete input selection.
Thanks you in advance for any help that you can provide. Mike
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.