Post 1 made on Thursday February 11, 1999 at 19:53 |
Craig MacKenna Historic Forum Post |
|
|
Bought a Pronto last week. Programmed it all up and almost everything works. What doesn't work is all 5 of the right-side physical buttons. The buttons themselves can be sensed by the Pronto because learning codes for them seems to work normally, and after going to Use mode, the little "IR out the top" animation says the Pronto is sending, but there's no effect on the target device.
Learning the same code into an on-screen button, or one of the two bottom physical buttons, works fine.
Any ideas? I downloaded the ProntoEdit SW but don't have a cable yet.
------------------ Craig MacKenna Los Gatos, CA
|
|
OP | Post 2 made on Friday February 12, 1999 at 11:15 |
Ken Faris Historic Forum Post |
|
|
Ask your questions in the Pronto section. This is area is for the IRIQ & H/K. Only George Mills a Pronto fan seems to hang out in this area.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.